Paint sprayer is a great innovation when it comes to painting. Mostly, paint used to be done using roller and brushes. It not only required a lot of physical labor, but was time consuming and messy as well. It is even more difficult if you wish to paint finer details, or very large areas, which may be different in texture than normal plain surfaces. However, now a day, more and more people are using paint sprayers to complete the job. Painting with a paint sprayer machine is quicker, much more efficient, cleaner and safer. There are many kinds of paint sprayers in the market.
Overview of the paint sprayer:
A paint sprayer is used to simplify painting. There are majorly two ways it does this, first being the speeding up of the painting job, since paint is applied twice as quickly as compared to a brush or roller. Secondly, you get a top class smooth finish, which is particularly important and attractive on the woodworks, doors and window sills. The paint sprayers are designed to paint evenly and are even suitable for runnier liquids like varnish and lacquer. However, you cannot reap the full benefits until you know some basic instructions on how to use the paint sprayer.
Step 1: After getting acquainted with your paint sprayer, you need to learn the few key setup points. At the intake point, there is a screen. You need to make sure it is clean. There is a removable filter somewhere around the pump and another near or in the handle. They need to be clean as well. Strain the desired paint so that any particles or clumps will not clog the sprayer.
Step 2: The next and most important step is to prime the pumps. This is especially important for the smooth application of paint. This is the step where you basically check the flow of paint before application as well as remover nay paint that may have been left over in the pipes, nozzle and spray hole after the last usage.
Step 3: Now to fill paint, hold the gun over the bucket and pull the trigger this will cause the gun to fill. Remember to carefully lock the trigger and release the pressure before you complete the installation of the tip guard and the tip. Release the trigger once you that the paint flows freely from the gun.
Step 4: The next step is to adjust the pressure. This is exceptionally important since a low pressure can cause a very untidy and uneven application, and too much pressure can cause over spraying of paint, gluttony texture and early peeling and fading. One way to know that your pressure is just right is to watch out for tails of paint. If there are tails, then this means that the pressure is too less. If tails still remain, then change the tip to a smaller tip. Also, you need to make sure that the tip is not worn out, since it can cause irregular spray.